上汽通用别克汽车维修手册-6c12S-C.pdf

SECTION 6C1-2 – DIAGNOSIS - V6 SUPERCHARGED ENGINE IMPORTANT: Before performing any Service Operation or other procedure described in this Section, refer to Section 00 CAUTIONS AND NOTES in VX Service Information for correct workshop practices with regards to safety and/or property damage. GENERAL DESCRIPTION This is where to start all driveability and emissions diagnosis, once you read and understand Section 6C1-1 GENERAL INFORMATION of the VX Series Service Information. The beginning of Section 6C1-2A contains reference material: wiring diagrams, control module terminal end views, and engine component locations. Remember, this information is for reference; do not start diagnosis using these pages. Always start diagnosis on the page titled Powertrain OBD System Check. This check verifies that the diagnostic circuits are operating properly, then sends you to the correct service information for diagnosis. If the initial steps in the Powertrain OBD System Check reveal a problem, or if the engine does not start, you will be using one or more tables in Section 6C1-2A of the VX Series Service Information for diagnosis. The Powertrain OBD System Check will send you to the correct table. These tables follow the Powertrain OBD System Check and problems that prevent the engine from starting. If the Powertrain OBD System Check shows that diagnostic trouble codes have been stored, proceed to the appropriate Diagnostic Trouble Code (DTC) diagnosis pages. If more than one diagnostic trouble code has been stored, always start diagnostic trouble code diagnosis with the lowest diagnostic trouble code number and work upward. Di