暂态录波型故障指示器技术条件和检测规范.docx

暂态录波型故障指示器技术条件和检测规范（试行）Technical requirements and inspection regulations forTransient state waveform recording type fault indicator暂态录波型故障指示器技术条件和检测规范Technical requirements and inspection regulations forTransient state waveform recording type fault indicator1范围scope 本标准规定了暂态录波型故障指示器（以下简称指示器）的使用条件、技术要求、选型原则、试验项目及方法等。This regulation stipulates the working condition, technical requirements, selection principle, testing subjects and methods of transient state transient fault indicator (use “indicator” for short in the following part).本标准适用于额定电压 6.6kV～35kV、额定频率50Hz的三相交流配电架空线路中监测负荷、指示、上报短路和接地故障线路区段信息的暂态录波型指示器。 This standard is suitable for the transient waveform recording indicator to monitor the load, indication, uploading short circuit and earthing faults, for the three phase AC distribution overhead line with rated voltage of 6.6kv-35kv and rated frequency of 50Hz.2规范性引用文件normative reference下列文件对于本文件的应用是必不可少的。凡是注日期的引用文件，仅所注日期的版本适用于本文件。凡是不注日期的引用文件，其最新版本（包括所有的修改单）适用于本文件。The following documents are essential to this regulation. For the cited documents with date, only the version with date is suitable for this document. If the cited document doesn’t have a date, the lasted version will prevail for the document.GB/T 2423.1-2008 电工电子产品环境试验 第2部分:试验方法 试验 A:低温 Electric and electronic products environmental test, part 2: testing method, test A: low temperature.GB/T 2423.2-2008 电工电子产品环境试验 第2部分:试验方法 试验 B:高温 Electric and electronic products environmental test, part 2: testing method, test B: high temperature.GB/T 2423.4-2008 电工电子产品基本环境试验规程 试验 Db：交变湿热试验方法 Electric and electronic products environmental test procedures, test Db: cyclic damp heat test.GB/T 2423.8-1995 电工电子产品环境试验 第2部分:试验方法 试验Ed:自由跌落Electric and electronic products environmental test, part 2: testing method, test Ed: free fall.GB/T 2423.17-2008 电工电子产品环境试验 第2部分:试验方法 试验Ka:盐雾 Electric and electronic products environmental test, part 2: testing method, test Ka: salt mist.GB 4208-2008 外壳防护等级（IP代码）Enclosure protection class (I