[计算机软件及应用]tems基本介绍与使用.pptVIP

August 11, 2000 Drive Test Procedure Preparation (1) Definition File Without it, it is impossible to observe overshooing neighbors GenDef7.exe can convert FP to definition file Preparation (2) Frequency Plan Configuration map Software:TEMS, FICS, GEP, VOT Hardware: TEMS, GPS, Portable PC Test Problem Sheet Route Map Drive Test For Benchmark 2 minutes per call 10 – 15 minutes a log files Force to appropriate band (GSM only, DCS only or Dual) For Special Problem Planning route No limitation TEMS Introduction Interface Functions Log File Process TEMS .log file Analysis Undecoded BCCH BSIC Undecode in Other Site No Handover Delay Handover Ping Pong Handover Negative Handover Overshooting High Overlapping No Dominant Server Undecoded BCCH (1) Description: BSICs can’t be decoded in 5s Usually consider 3 strongest neighbors Reason: GCLK shift, only decode same site BSICs Channel interference Non-BCCH carrier, no dedicated spectrum for BCCH Undecoded BCCH (2) BSIC Undecode in Other Site Description: BSIC in same site can be decoded but not for other sites Handover can only happen in intra-site basis It is similar to former Undecoded BCCH case Reason: GCLK shift GCLK recalibration is required No one monitors OMC-R alarms No Handover (1) Description: Neighbor BSIC is decoded and COMMON handover requirement is fulfilled but there is never a handover Reason: Missing neighbor No such neighbor in CM database Incorrect external neighbor Target cell’s LAC/BCCH/BSIC in add_neighbor is different from those in equip_rtf Engineer modifies external neighbor at MMI, not through GUI Never use OMC-R Proxy Cell to propagate external neighbor information N hreqt. Great HO_MARGIN. Improper algorithm 1-7 setting Missing_rpt =1 Serving cell overshoots/covers too far away Refer to GSM BSS Statistics Analysis Handbook No Handover (2) Delay Handover (1) Description: Neighbor BSIC is decoded but handover occurs in much later time Reason: All possible neighbors suffer blocking Large hr