高频发射机设计.docVIP

编号： （高频电路设计与制作） 实训论文说明书 题 目： 调频发射机 院 （系）： 信息与通信学院 专 业： 电子信息工程 学生姓名： 学 号： 指导教师： 2012年 12月27日 摘 要 我的高频实训主要是设计一个调频立体声发射器。发射的主要任务是完成有用的低频信号对高频载波的调制将其变为在某一中心频率上具有一定带宽、适合通过天线发射的电磁波。重点在于设计能给发射机电路提供稳定频率的振荡调制电路。适当放大语音信号，以配合调制级工作；然后用构成振荡电路为发射机提供基准频率载波，接着通过完成语音信号对载波信号的频率调制，最终利用功率放大，使已调制信号功率大大提高，经过串联滤波网络滤除高次谐波，最后通过拉杆天线发射出去。通过后续电路的调试，可以证明本课题的电路基本成熟，基本能完成语音信号的电压放大、频率调制和功率放大，达到发射距离的要求调频；立体声；发射器；LC振荡；高频放大；功率放大；输出滤波 Abstract My design is a high frequency training design a FM stereo transmitters. Launcher is the main task of the complete useful low frequency signal of the high frequency modulation of the carrier, and turn it into a center in frequency has certain bandwidth, suitable for through the launch of the electromagnetic wave antenna. Training focus is to design can give transmitter circuits provide stability of the oscillation frequency modulation circuit. First through the amplifier amplification appropriate speech signal to match a level; Then use capacitance SanDianShi constitute oscillating circuit for transmitter provide benchmark frequency carrier, and then through the change of speech signal to finish speech signal carrier signal frequency modulation, finally using c class power amplifier, make already modulation signal power greatly improved, after series filtering network higher harmonic filter, the last through the bars antenna launch out. Through subsequent circuit debugging, can prove this topic circuit basic mature, basic can finish speech signal voltage amplifier, frequency modulation and power amplifier, to launch the distance of the requirements. The design of the FM transmitter commissioning of the results: center frequency 101 MHZ, fengfeng value 210 mv, the transmission distance 21 m, sound quality general and meet the design requirements. The transmitter can be used in home entertainment, baby sleep monitoring and all kinds of indoor