ds1302时钟显示.docVIP

//DS1302在使用的时候要加上拉电阻！！！不加上拉会出现驱动力不够，而使 数码管缺段显示！ #includereg52.h #includeintrins.h #define uchar unsigned char #define uint unsigned int #define date0 second0 #define date1 second1 #define month0 minute0 #define month1 minute1 #define week0 hour0 #define week1 hour1 sbit DS1302_CLK = P1^2; //实时时钟时钟线引脚 sbit DS1302_IO = P1^3; //实时时钟数据线引脚 sbit DS1302_RST = P1^4; //实时时钟复位线引脚 sbit ACC0 = ACC^0; sbit ACC7 = ACC^7; sbit time= P3^2; sbit date= P3^3; sbit second0 = P2^0; sbit second1 = P2^1; sbit minute0 = P2^2; sbit minute1 = P2^3; sbit hour0 = P2^4; sbit hour1 = P2^5; sbit year0 = P2^6; sbit year1 = P2^7; uchar now_time_date[8]={0x00,0x24,0x14,0x03,0x15,0x04,0x09,0x00};//秒，分，时，星期，日，月，年,禁止写 //code uint table[]={0x3f,0x60,0x5b,0x4f,0x66,0x6d,0x7d,0x70,0x7f,0x6f}; code uint table[]={ 0xc0,0xf9,0xa4,0xb0,0x99,0x92,0x82,0xf8,0x80,0x90}; //显示段码 数码管字跟 /******************延时*********************/ void delay(uint i) { uint j=0; for(;i0;i--) for(j=0;j100;j++); } /******************结束*********************/ /******************DS1302：写入操作(上升沿)*********************/ void DS1302InputByte(uchar d) //实时时钟写入一字节(内部函数) { unsigned char i; ACC = d; for(i=8; i0; i--) { DS1302_IO = ACC0; //相当于汇编中的 RRC DS1302_CLK = 1; DS1302_CLK = 0; ACC = ACC 1; } } /******************DS1302：读取操作（下降沿）*****************/ uchar DS1302OutputByte() //实时时钟读取一字节(内部函数) { unsigned char i; for(i=8; i0; i--) { ACC = ACC 1; //相当于汇编中的 RRC ACC7 = DS1302_IO; DS1302_CLK = 1; DS1302_CLK = 0; } return(ACC); } /******************DS1302:写入数据（先送地址，再写数据）***************************/ void Write1302(uchar ucAddr, uchar ucDa) //ucAddr: DS1302地址, ucData: 要写的数据 { DS1302_RST = 0; DS1302_CLK = 0; DS1302_RST = 1; DS1302InputByte(ucAddr); // 地址，命令 DS1302InputByte(ucDa); // 写1Byte数据