RationalDMIS V6.5三坐标测量软件三坐标测量仪配套软件.docx

User Manual Eagle.Virtual.COM v1.0.0 phone: Document name: UM-Pantec Engineering AG +423/377 13 33 80415A_EN.doc Industriering 21 fax: +423/377 13 34 Document revision: Rev. A 9491 Ruggell mail: info@ Language: EN Principality of Liechtenstein internet: Release date: 2011-06-10 These operating instructions are aimed at the person in charge of the factory who must pass it on to the personnel responsible for assembly, application and maintenance of the controller. The person in charge must make sure that the information contained in the operating instructions and in the accompanying documents is read and understood. The operating instructions must be kept in a known and easily accessible place and must be consulted for advice whenever there is the slightest doubt. The manufacturer does not accept any liability for injury to persons or animals or for damage to goods, the controller or the system itself caused by improper use, nonobservance or insufficient observance of the safety criteria listed in these assembly instructions, or caused by changes to the controller or use of non-suitable replacement parts. The copyright for these operating instructions is the exclusive property of PANTEC Engineering AG LI-9491 Ruggell or its legal heirs. These operating instructions may be reproduced or passed on to third parties only when written consent has been obtained. This applies also when only sections of the Operating Instructions are copied or passed on. The same terms govern the transmission of the Operating Instructions in digital form. PANTEC Engineering AG Industriering 21 9491 Ruggell Liechtenstein Telephone: +423 377 13 33 Fax: +423 377 13 34 Subject to change without prior notice. 1 - Table of Contents Table of Contents 1. Table of Contents3 2. Document revision notes4 3. General Information5 3.1. Limitation5 3.2. What is to be observed in reading the documentation5 3.3. Service6 3.4. Liability6 3.5. Definition and Abbreviati