电厂综合水泵房水泵变频调速控制系统设计_毕业设计说明书p46.docVIP

本科生毕业设计说明书（毕业论文） 题 目：电厂综合水泵房水泵变频调速控制系统设计 电厂综合水泵房水泵变频调速控制系统设计 摘要 本论文根据要求，系统KW水泵，变频泵定时循环运行，一周自动切换一次，当变频泵不能满足要求时，自动软启动一台工频泵,当变频泵仍然不能满足压力给定值时，再自动软启动第三台水泵。 工业补给水泵系统（一控二），其变频柜只控制两台37KW小泵，水泵不要求定时循环运行，但能够手动切换运行。当变频泵不能满足要求时，自动启动另一台工频小泵。75KW大泵只能工频手动控制，不参与变频自动控制。 两套系统的基本构成均由变频器PID）、、压力传感器等构成用变频器水泵电机的软启动和速压力器检测当前水压，送入PID控制器与设定值比较后PID运算，变频器的输出，改变水泵电机的转速改变供水量，最终管网压稳定在设定值附近。PID、调速 The Design of Frequency Control System of an Integrated Water Pump House of a Power Plant Abstract This paper is based on technical requirements of an integrated water pump house of a power plant. It is intended for water lift pump and industrial water supply pump frequency control two systems transformation. Where the water lift pump system (one control three), its variable frequency counter control three pumps of 75KW, these pumps need timing loop operation, one week automatically switch once. When one pump can not meet the requirements, automatically starts frequency pump, when two pump still can not meet the pressure setpoint, and then a third pump automatic soft starts. Industrial supply pump system (one control two), its variable frequency counter only control two small pumps of 37KW, the two pumps do not require timing loop to run, but the?system can be run manually, when one pump can not meet the requirements, automatically starts another small pump. 75KW large pump only manual control by power frequency and it does not participate in frequency control. The basic structure of the two systems by the frequency inverter (including PID), soft starter, motor, pressure sensors, etc. and both two systems have taken advantage of the inverter to control the pump motor soft start and speed. Pressure transmitter used to detect current pipe pressure of pump, in the form of electrical signals sented into the PID controller of inverter and compared with the set value , after that the PID operation is performed, which is to control the inverter output frequency and voltage, thus changing the pump motor