超声波—缺氧好氧组合的体系的构建.docVIP

本科毕业设计（论文）超声波—缺氧/好氧组合体系的构建学 院 环境科学与工程学院 专 业 环境工程 年级班别 2005级（4）班 学 号 学生姓名 指导教师 2009 年 6 月设 计 总 说 明污泥原位减量化技术是解决目前污水处理过程中产生剩余污泥问题的重要途径。本文设计的超声波-缺氧/好氧组合工艺实验模型是将超声波处理与缺氧/好氧(A/O)工艺相结合对污泥进行原位减量化。首先采用超声波直接对回流污泥进行超声处理，然后将超声波处理后的回流污泥返回缺氧池以及好氧池进行隐性生长，减少后续的剩余污泥产出量。同时，该设计并未影响出水水质。本文侧重对模型的设计，关键是缺氧、好氧同池部分以及沉淀池、超声波处理器的设计与选择。模拟设计与常规工艺的实际设计有一定差别，部分参数是探索性的选择。关键词：超声波，缺氧/好氧，模型，污泥减量化. General Specification of DesignReduction of sludge is one of the biggest challenges in the biological wastewater treatment processes. In this paper, an ultrasonic-anoxia/aerobic was designed to reduce sludge, using the technology of ultrasonication that is combined with anoxia/aerobic craft in this text. At first, using ultrasonic to disintergrate returned sluge directly, and then put the returned sluge back to the anoxic tank and aerobic tank for cryptic growth, which could contribute to the slugde reduction. This design does not impact the quality of treated water at the same time.This HYPERLINK /text/ study emphasized especially on HYPERLINK /model/ model designing, the key was the selection of design HYPERLINK /parameter/ parameters about the tank for anoxia / HYPERLINK /aerobic/ aerobic and sedimentation, also about the ultrasonic HYPERLINK /processor/ processor. This design was HYPERLINK /difference/ \t _blank different from HYPERLINK /actual/ \t _blank actual project, because HYPERLINK /part/ \t _blank part of the HYPERLINK /parameter/ parameters was HYPERLINK /dict_result.aspx?searchword=%e6%8e%a2%e7%b4%a2%e6%80%a7tjType=sentencestyle=t=explorative explorative selection. Key words:Ultrasonic, Anoxia/ HYPERLINK /aerobic/ aerobic, Prototype, HYPERLINK /sludge/ \t _blank Sludge reduction目 录1 绪论…………………………………………………………………………………11.1 设计参考水量与水质………………………………………………………… 1 1.2 我国城市主要污水处理工艺及其特点……………………………………… 1 1.3 我国污泥发展概况与污泥减量化的提出…………………………………… 2 1.4 超声波技术与污泥处理…………………………………………………