【AS澳大利亚标准】AS 2505-2-2004 Metallic materials Method 2 Bars, rods and solid shapes—Bend tests.docVIP

Accessed by UNIVERSITY OF SOUTH AUSTRALIA on 27 Feb 2007 Accessed by UNIVERSITY OF SOUTH AUSTRALIA on 27 Feb 2007 AS 2505.2—2004 1 AS 2505.2—2004 Australian StandardTM Metallic materials Method 2: Bars, rods and solid shapes—Bend tests PREFACE This Standard was prepared by Standards Australia Committee MT-006, Mechanical Testing of Metals to supersede AS 2505.2—1989, Methods for bend and related testing of metals, Method 2: Bars, rods and solid shapes. The objective of this revision is to introduce new testing and reporting requirements for bend tests for bars, rods and solid shapes. This Standard is Method 2 of a series of Standards on the methods of bending wire and related testing of metals. The series comprises the following Methods: AS 2505 Metallic materials 2505.1 Method 1: Sheet, strip and plate—Bend tests 2505.2 Method 2: Bars, rods and solid shapes—Bend tests (this Method) 2505.3 Method 3: Tubular products—Bend and related tests 2505.4 Method 4: Wire—Reverse bend test 2505.5 Method 5: Wire—Simple torsion test 2505.6 Method 6: Wire—Wrapping test This Standard does not cover bend testing of welds, which is dealt with in the series of Standards, AS 2205, Methods of destructive testing of welds in metals. METHOD 1 SCOPE This Standard specifies methods for simple and reverse bend testing in the longitudinal direction of coated and uncoated metal bars, rods and solid shapes. NOTES: 1 Criteria for assessment of the results of tests are not included; they are specified in appropriate product Standards. 2 Where angles of bend of test pieces are specified in product Standards, they are deemed to be minimum angles. However, where radii of bends of mandrels or formers are specified, they are deemed to be maximum radii. 2 DEFINITIONS For the purpose of this Standard, the definitions below apply. Accessed Accessed by UNIVERSITY OF SOUTH AUSTRALIA on 27 Feb 2007 AS 2505.2—2004 2 2.1 Longitudinal bend test piece A test piece in whi