ASTMA182_A182M16高温下使用锻制或轧制合金-不锈钢钢管法兰-锻制管件-阀门及零件标准规范.pdf

Designation: A182/A182M − 16 Endorsed by Manufacturers Standardization Society of the Valve and Fittings Industry Used in USDOE-NE Standards Standard Specification for Forged or Rolled Alloy and Stainless Steel Pipe Flanges, Forged Fittings, and Valves and Parts for High-Temperature Service1 This standard is issued under the fixed designation A182/A182M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the U.S. Department of Defense. 1. Scope* 1.6 The values stated in either SI units or inch-pound units 1.1 This specification2 covers forged low alloy and stainless are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each steel piping components for use in pressure systems. Included are flanges, fittings, valves, and similar parts to specified system may not be exact equivalents; therefore, each system dimensions or to dimensional standards, such as the ASME shall be used independ