T形钢连接梁柱半刚性节点初始转动刚度计算公式.PDFVIP

第 52 卷第 10 期 浙 江 大 学 学 报 (工学版) Vol.52 No.10 2018 年 10 月 Journal of Zhejiang University (Engineering Science) Oct. 2018 DOI: 10.3785/j.issn.1008-973X.2018.10.013 T 形钢连接梁柱半刚性节点初始转动刚度计算公式 夏永强，肖南 (浙江大学 建筑工程学院，浙江 杭州 310058) 摘 要：为了确定T 形钢连接半刚性节点的初始刚度，分析T 形钢连接梁柱节点的变形特征. 以节点处与梁端受拉 侧翼缘相连的T 形钢为研究对象，将T 形连接件翼缘受力视为简支梁，建立T 形钢连接节点在弹性阶段的初始 转动刚度计算模型，推导初始转动刚度的计算公式. 采用数值模拟和已有试验数据，对所推导公式进行对比分析. 结果表明，节点的初始转动刚度主要取决于T 形钢连接件的翼缘厚度、T 形钢翼缘上螺栓的位置和梁的高度，通 过推导公式所得的初始刚度大于数值模拟和试验所得刚度. 为了更加准确地预测节点初始转动刚度，引入刚度 修正系数，分别采用修正后的刚度公式和已有的计算公式计算案例. 结果表明，修正后的刚度公式能够更好地符 合试验结果. 关键词： T 形钢连接节点；半刚性连接；初始转动刚度；有限元分析(FEA) 中图分类号： TU 312 文献标志码： A 文章编号： 1008−973X（2018 ）10−1935−08 Initial rotational stiffness formula of semi-rigid joint with T-stub in beam-to-column connection XIA Yong-qiang, XIAO Nan ( College of Civil Engineering and Architecture, Zhejiang University , Hangzhou 310058, China) Abstract: The deformation characteristics of the joint were analyzed in order to determine the initial stiffness of semi-rigid joint with T-stub. Then the flange of T-stub bolted on the tensile side of the beam section, which was deemed as main research object, was regarded as simply supported beam. The calculation model for the initial rotational stiffness of the joint during elastic phase was established, and the analytical formula of initial rotational stiffness was deduced. Numerical simulation and experimental data were employed for comparison with the results from the proposed formula respectively. Results show that the initial rotational stiffness of the joint mainly depends on the flange thickness of the T-stub, distance between bolts linking the flange of T-stub to