远程时控报警系统设计.docVIP

序号（学号〉： 序号（学号〉： 021240331 长春大学毕业设计（论文） 远程时控报警系统设计 2016 2016年 5月 31日 姓 名 周剑东 学 院 电子信息工程学院 专 业 电气工程及苏自动化 班 级 12403 指导教师 王英霞（副教授） 远程时控报警系统 随着当今社会经济的飞速发展，防范火灾工作显得H趋重要。所以，就有 必要来研制一种结构比较简单、经济II实用的温度烟雾检测及远程报警系统来满 足人们的需要。将火灾消灭萌芽之屮，使财产的损失得到大幅度减少。 这次设计主耍是以单片机及远程报警系统设计的核心部分。利用了单片机 AT89C51和时钟芯片温度传感器DS1302可以根据需要配合各种采集器检测例如 空气中的温度和烟雾浓度，并且通过单片机来判断温度和烟雾浓度指数是否超 标，如果超标报警器会发出声光报警。当发生火灾吋远程发射模块可以对指定接 收器发出报警信息。 此系统能够自动对布测点进行温度和烟雾检测，确认达到报警的标准之后能 够自动报警。本系统可以安装在各个单位，用来监视现场烟雾浓度、温度，并且 不断反馈给控制器，控制器将报警的标准值与接到的信号的转化值进行比较，判 断是否有火灾发生。如果发生火灾，这是一种结构比较简单、价格比较便宜、使 用比较方便、性能相对稳定、智能化报警系统，并且具有一定的实用价值。 关键字:远程报警系统，单片机，传感器 ABSTRACT Along with the rapid economic development of today’s society, to prevent the fire work is increasingly important. So, it is necessary to develop a simple economic structure, and practical temperature and smoke detection and remote alarm system to meet the needs of the people. Will fire kill in the bud, make the loss of property. This design with the single chip processor and smoke and smoke sensor as the temperature detection and the core part of the remote alarm system design, using AT89C51,DS1302 and smoke sensors to detect temperature and smoke concentration in the air, to judge whether the temperature and smoke concentration index to exceed bid, if excessive alarm sends out sound and light alarm. In addition, this design also installed the remote launch module and display module, display module can show the current environment of temperature and smoke concentration, when the fire remote launch module to specify the receiver sends out alarm information. This system can detect the BuCe point automatically, after confirmation reached the standard of alarm will automatically alarm the system can be installed in all fire protection unit, used to monitor the scene of the smoke temperature, concentration and feedback to the controller, the controller will alarm values and received signal conversion values are compared to judge whether a fire. If there is a fire, this system can imp