角钢桁架型钢混凝土梁的复合受扭性能研究-结构工程专业论文.docxVIP

Master Dissertation of Suzhou University of Science and Technology Research on combined torsional behavior of angle steel truss reinforced concrete beams Master Candidate: CHENG Jian Supervisor: SHAO Yong-jian Major: Structural Engineering Suzhou University of Science and Technology Department of Civil Engineering June, 2012 苏州科技学院硕士学位论文摘要 苏州科技学院硕士学位论文 摘要 I I 摘 要 作为一种新型结构形式，型钢混凝土结构具有承载力高，抗震性能好等优点， 在工程界得到了广泛的应用。在我国，对型钢混凝土已进行了广泛而深入的研究， 但对于其抗扭性能的研究却非常少，因此，对复合扭矩作用下的型钢混凝土梁性 能研究有着重要的工程应用前景。 为了研究角钢桁架型钢混凝土梁在复合扭矩作用下的受力性能，分别进行了 6 根角钢桁架型钢混凝土梁的弯扭和剪扭试验。通过试验研究，揭示了角钢桁架 型钢混凝土梁在复合受扭作用下的受力机理与破坏形态及裂缝的开展与分布情 况；分析了角钢桁架型钢混凝土梁复合受扭性能的影响因素。在试验实测数据的 基础上，提出了角钢桁架型钢混凝土梁复合受扭的开裂扭矩和极限扭矩计算公 式。 试验结果表明：角钢桁架型钢混凝土梁比普通钢筋混凝土梁的抗扭性能有很 大的提高，大体上随着腹杆体积配钢率的提高而增大；适当的弯矩可以提高角钢 桁架型钢混凝土梁的极限扭矩；一定的剪力施加则会降低角钢桁架型钢混凝土梁 的极限扭矩。 关键词：角钢桁架，型钢混凝土，复合扭矩，受力性能，开裂扭矩，极限扭矩 基金项目：国家自然科学基金、江苏省企业研究生工作站（苏州二 建建筑集团有限公司） Master Master Dissertation of Suzhou University of Science and Technology Abstract II II Abstract As a new structural form, steel reinforced concrete (SRC) structures have a lot of advantages, such as high bearing capacity, excellent seismic performance, and they are used increasingly more for engineering world. In our country, SRC is extensively and deeply researched, but there are only little studies on the behavior of SRC beams under torsion. So, there is an important practical meaning as well as a broad application prospect to study the performance for SRC beams under combined forces bending, shear and torsion. In order to study the capacity of angle steel reinforced concrete (ASRC) beams under combined torsion, 6 ASRC beams were carried out respectively. Through the experiment research reveals the working mechanism, failure modes and appearance and development of cracks under combined torsion, the factors of effect on the capacity were also analyzed. Based on the experimental data, the calculation equation of the cracking torque and the ultimate torque of ASRC beams are put forward. The results of this exp