基于虚拟技术的便携式吊牌穿线打结机的模拟设计与仿真分析-机械制造及其自动化专业论文.docxVIP

摘要 吊牌的使用在制造生产中普遍存在，但是吊牌的安装尚未实现机械化与低成 本化。机械化打结技术是目前研究的热点和难点，它的研究结果不仅为吊牌的智 能化安装奠定技术基础，而且也可以广泛地应用于其他领域。 本文在充分了解国内外打结器研究现状的基础上，对吊牌穿线打结机进行方 案制定与时序设计；运用自顶向下的方法，利用 Solidworks 软件对穿线打结机进 行三维设计建模与虚拟装配；导入 ADAMS 软件中进行虚拟仿真分析，得出送线 机构、钩线机构、拨线机构、挑线机构和打结机构的运动特性曲线，并对运动特 性曲线进行了分析。最后依据有限元方法和疲劳损伤理论，在 Simulation 模块下进 行了打结嘴的静力分析和疲劳分析，结果表明设计满足寿命要求。 关键字：穿线打结机 功能分析法 三维建模 动态仿真 静力分析 疲劳分析 Abstract Now the tag is widely used in the manufacturing, however the installation of tag has not been mechanized and its cost has not been cut down. Although the mechanization knotting technique is currently hot and difficult point in the research about knotting tag, its result not only will lay the foundation for the intelligent installation of tag, but also can be widely applied to other fields. On the basis of full understanding of domestic and international knotter research, the thesis presents the design plan and the time sequence of tag knotter. According to top-down theory, three-dimensional assembly model of tag knotter was built in Solidworks. Make virtual simulation in ADAMS to get the kinetic characteristic curves of feeding line mechanism, line mechanism, pulling line mechanism, adjusting line mechanism and knotting mechanism. In addition, do some analysis on the curves above. Finally, according to the theory of finite element method and fatigue damage, a static analysis and a fatigue analysis were made in the simulation software. The results showed that the design satisfy the life expectation requirements. Keywords：Tag-threading knotter Function analysis method Fatigue analysis Three-dimensional modeling Dynamic simulation Static analysis 目录 HYPERLINK \l _bookmark0 第 HYPERLINK \l _bookmark0 1 HYPERLINK \l _bookmark0 章 HYPERLINK \l _bookmark0 绪论 HYPERLINK \l _bookmark0 1 HYPERLINK \l _bookmark1 1.1 引言 1 HYPERLINK \l _bookmark2 1.2 各种打结方法的国内外研究现状 1 HYPERLINK \l _bookmark3 1.2.1 牧草打捆机 1 HYPERLINK \l _bookmark4 1.2.2 票据自动捆扎机 4 HYPERLINK \l _bookmark5 1.2.3 外科手术机器人 4 HYPERLINK \l _book