高低瓦楞辊齿形尺寸参数研究-包装工程.PDF

第35卷摇 第9期 摇 摇 摇 包 装 工 程 摇 摇 2014年05月 摇 摇 摇 摇 PACKAGING ENGINEERING 摇摇摇 47 高低瓦楞辊齿形尺寸参数研究 潘光华,柏子游,王冬梅 (深圳职业技术学院,深圳518055) 摘要: 目的摇 研究一种“高低瓦楞辊冶组的齿形及具体尺寸,为制造高低瓦楞辊组提供设计参数,从而 生产出高低瓦楞夹芯。 方法摇 在分析传统“等高瓦楞辊冶齿形及有关标准尺寸参数基础上,预先确定 基本尺寸参数值,并采用AutoCAD设计制图得出瓦楞辊齿形其他尺寸参数,然后模拟瓦楞辊滚压纸板 过程,并测量纸板在瓦楞辊齿上的包角。 按照纸板成形过程中张力的必要条件验算纸板成形的可行 性,反复设计验算。 结果摇 得出了高低瓦楞辊齿形尺寸参数值。 结论摇 这种齿形尺寸参数的高低瓦 楞辊能使纸板在瓦楞辊齿上的包角值为340毅和332毅,达到纸板成形过程张力要求,可作为高低瓦楞辊 齿形尺寸参数。 关键词:瓦楞辊;高低瓦楞辊;等高瓦楞辊;齿形;包角;尺寸参数 + 中图分类号:TB486 .03摇 摇 摇 文献标识码:A摇 摇 摇 文章编号:1001-3563(2014)09-0047-05 Tooth Size Parameters of High and Low Corrugated Roller PAN Guang-hua,BAI Zi-you,WANGDong-mei (Shenzhen Polytechnic,Shenzhen518055,China) ABSTRACT:Objective To provide a new tooth profile and size of High and Low corrugated roller,in order to provide a reference forcorrugatedrollergroupandcorrugatedsandwichmanufacturing. MethodsItwasbasedontheanalysisof sometra鄄 ditional equal-high corrugated roller tooth profiles and relative standard size parameters. Parameter values of basic sizes were determinedfirstly,andtheother sizeparametersof corrugatedrollertoothwerethenobtainedbyAutoCADsoftware. After that,the rolling process ofcorrugatedrolleronthecardboardwassimulatedandthewrapangleofthecardboardonthecorruga鄄 ted roller was measured. Thefeasibility of cardboardforming was verified according to necessary condition of tension in card鄄 boardforming process. Results The high and low corrugated roller tooth size parameter values were obtained. Conclusion U鄄 sing the HighandLow corrugatedroller withthistoothsizeparametervalues,thecardboardcouldformawrapangleof340毅 or332毅 onthe corrugated