光纤锥气相刻蚀的制备方法研究-光学工程专业论文.docxVIP

AbstractAbstract Abstract Abstract h tlle early 1 960s，the invention of the laser and the maturity of the optical fiber manufacture technology,make it play role in practical application．Optical fiber is widely used in communication，optical storage，optical fiber sensors，because it has good stability,high speed transmission ofhigh quality and high sensitive sensors．The Iimitation of the fiber in use also gradually emerges．1ike most of science and technology．In order to break through the limit of fiber optic，scientists set out to optical fiber micro processing，thus greatly expand the application field of optical fiber． Fiber optic taper production is of the many optical fiber micro-processing technologies，which gets much better in the actual production process．Optical fiber has been widely used in many fields，because of its unique structure，high sensitivity sensing and the micro performance advantages．Its application areas include physical，material，chemistry,medicine and life science，etc． Aiming at the defects of existing methods that in the optical fiber taper production， the paper puts forward a method based on the traditional chemical corrosion． Vapor-phase etching is based the traditional chemical etching method and the pipe corrosion method adopted in the coating layer of fiber processing，aS well the method of using micro convection in the gas of I-IF to make the optical fiber taper． ，nlis method Can make fiber optic taper with different size．At the same time，it has simple operation，low production cost，hi【gh experimental repeatability etc． In the first chapter,we fh-stly introduce the performance of the optical fiber taper scope of application．Then，we in订oduce the several current fiber production methods．However，there still exist some production problems and the insufficiency of these methods．Finally,the research significance of this paper is briefly elaborated． In the second chapter,we introduce the structure and characteristics of optical fiber and optical fibe