用集中控制控制政策和App路由策略配置多个传输和流量工程-Cisco.PDFVIP

用集中控制控制政策和App路由策略配置多个传输 和流量工程 Contents Introduction Prerequisites Requirements Components Used 配置 问题 解决方案 Verify  Troubleshoot Related Information Introduction 本文描述如何配置集中控制控制政策和app路由策略达到在站点之间的流量工程。也许考虑作为特 定的用例一个特定设计指南。 Prerequisites Requirements There are no specific requirements for this document. Components Used This document is not restricted to specific software and hardware versions. The information in this document was created from the devices in a specific lab environment.All of the devices used in this document started with a cleared (default) configuration.如果您的网络处于 活动状态，请确保您了解所有命令的潜在影响。 配置 为演示和以后被描述的对问题的更好的了解的目的，请考虑在此镜像显示的拓扑。  请注意，那一般在vedge1之间的和vedge3您应该有第二条链路/子接口事务互联网TLOC扩展名的 ，但是这里为了未配置简单缘故的。 这是vEdges/vSmart的对应的系统设置(vedge2表示其他站点) ： 主机名- 站点id 系统IP vedge1 13 个 vedge3 13 个 vedge4 4 vedgex X vsmart1 1  您能找到传输旁边配置供参考。 vedge1 ： vedge1# show running-config vpn 0 vpn 0 interface ge0/0 description ISP_1 ip address /24 nat respond-to-ping ! tunnel-interface encapsulation ipsec color biz-internet no allow-service bgp allow-service dhcp allow-service dns allow-service icmp allow-service sshd no allow-service netconf no allow-service ntp no allow-service ospf allow-service stun ! no shutdown ! interface ge0/3 description TLOC-extension via vedge3 to ISP_2 ip address /24 tunnel-interface encapsulation ipsec color public-internet no allow-service bgp allow-service dhcp allow-service dns allow-service icmp no allow-service sshd no allow-service netconf no allow-service ntp no allow-service ospf allow-service stun ! no shutdown ! ! ip route /0 ip route /0 0 ! vedge3 ： vpn 0 interface ge0/0 description ISP_2 ip address /24 nat respond-to-ping ! tunnel-interface