大型模锻液压机监控系统设计研究.PDFVIP

2010 仪 表 技 术 与 传 感 器 2010 1 Instrum ent Techn ique and Sensor No1 熊欢欢, 黄明辉, 湛利华, 赵啸林 (, 410083) : 结合大型模锻液压机的工艺因素及高精度同步 行控制的要求, 对大型模锻液压机控制系统的组成和工作原 理进行了详细说明, 给出了系统的硬件配置以W inCC V 为软件平台, 设计开发了上位机监控系统, 实现了现场状态及 数据的监控, 并通过 C脚本程序完成了上位机对 PLC控制参数的设置实际应用表明, 该系统位置控制精度高, 人机界 面友好, 操作方便, 各项控制功能均达到了设计要求 : 模锻液压机; 监控系统; W inCC : TP273 : A : 1002- 1841( 2010) 01- 0092- 03 Monitoring System of Large Die ForgingHydrostatic Press XIONG H uanhuan, HUANG M inghui, ZHAN Lihua, ZHAO X iaolin (School ofMechanical and ElectricalEngineering, entral South University, hangsha 410083, hina) Abstract:A ccording to them aterial techn iques of largescale die forging hydrostatic press and accuracy synchronous control request, the composition structure and principle of the control system w as introduced, and the hardware configuration was provided. The upper com puter mon itoring and con trolling system based on W inCC V w as exploited, it comp leted data collection and state m on itory, and finished the PLC con trolling param eters setting BY m ass C language. The tests prove that the position control of the system has high precis ion, theHM I of the system is am icable and it is used conveniently, all con trolling functions reach the prmi ary technical requ irements. K ey words: d ie forging hydrostatic press; m onitoring and controlling system; W inCC 0 , , 5, , , , (), , , 4 , 4, , 2 1, 2, ,