冷带轧机轧辊偏心补偿控制关键技术研究-控制理论与控制工程专业论文.docxVIP

燕山大学工学硕士学位论文Abstract 燕山大学工学硕士学位论文 Abstract The research ofroller eccentricity is the important part ofthe research of the control technology ofhigh-quality strip rolling．With the increasing request ofthe every walk of life to st@quality,influence affected by the eccentricity in strip quality has no longer been neglected and becomes the hotspot problem in the study of realm of modern strip rolling．Although it has had a lot of achievements in rofler eccentricity research domain in our country,there is a relative gap compared with the developed countries．And there are many questions both in practical appliance and theory． This paper is based on the full investigation and practices；the research aiming at a few key techniques which are baffling the improvement of eccentricity compensation was carried on deeply．耽e corresponding conclusion and a new method forward were presented,and some simulation experiments were carried OIL Firstly,based on the completely familiarity with the cold rolling control system and the principle of the AGC，we propose dynamic structure of the AGC system with the eccentricity compensation and simplified structure of eccentricity compensation controL For the existed problem that applying the signal of eccentricity compensation to the control system directly,we propose the efficient method of determining of the eccemricity compensation signal， which is based on the relation between the eccentricity compensation signal and the丘equency feature ofposition closed loop system． Secondly,the limitation ofthe FFT(Fast Fourier Transform)in practice is discussed based on the basic theory of FFT．Combine the characteristic of the Harming window in time domain and frequency domain，a new method that is used in the process ofeccentricity signal extraction where the spectrum leakage occurred is offered,this method is named interpolation method of FFT based on the Harming window． Ⅱ Abs仃actLastly，we Abs仃act Lastly，we analyze the partial sway phenomenon ofthe ecce