水稻插秧机的安调试技术解析.docVIP

水稻插秧机的安装调试技术解析 2.1整机装置 2.1 the device 　　插秧机的根本结构由发动机、传动体系(变速箱)、行走组织(转向离合器、驱动轮)液压仿形体系、操作和调理组织、取秧量调理组织、移箱器等组成。出厂时,将这些部件包装运到各地,购机户应在技能人员的指导下,按插秧机说明书的需求进行装置。 The fundamental structure of transplanter by engine, transmission system ( Gearbox ), walking Organization ( steering clutch, a driving wheel ) hydraulic profiling system, operation and organization, the seedling conditioning conditioning organization, shift box etc.. The factory, the packaging of these parts around the world, farmers purchase should be under the guidance of technical staff, according to rice transplanter specification requirements. 　　2.2装置需求 The 2.2 device requirements 　　装置技能需求、装置质量直接影响插秧机的作业质量。因而,装置后应到达以下技能需求:一是各运动件装置后,转变应活络,无磕碰、卡阻表象,对运动件应加注光滑油。二是操作手柄(杆)转变活络,转向离合器转向自若,发动机油门操作组织应简便,并能精确操控发动机转速。三是一切紧固的当地,都应按规则拧紧。离合器别离完全,联系平稳。四是各传动部件,不允许有漏油表象,作业作业应正常。五是各空隙调整正确。如秧针与导轨插口旁边面的规范空隙为1.3～1.7 mm,秧针和苗箱旁边面的规范空隙为1.5～2.5 mm。 Device skill requirements, equipment quality directly affects the operation quality of rice transplanter. Therefore, after the device should reach the following skills requirements: one is the motion device, change should be active, no bump, blocking representation, on moving parts should add oil. Two is the operating handle ( rod ) change the active steering, steering clutch and engine throttle operation, organization should be simple, and can precisely control the engine speed. Three of all the fastening of local, should be in accordance with the rules to tighten. Clutch separate completely smooth, contact. The four is the transmission parts, oil spills image does not allow, homework should be normal. The five is the correct gap adjustment. Such as seedling needle and guide the specification for the 1.3 socket next gap to 1.7 mm, and the seedling seedling needle box beside the surface gap is 1.5 ~ 2.5 mm specification. 　　2.3插秧机的试作业 2.3 transplanting test machine 　　插秧机装置调整后,要进行试作业,在作业中查验装置质量。若是发现问题,应及时扫除,使插秧机处于最佳技能状况,投入作业。按插秧机运用说明书的需求,给发动机加足燃油,对各部位加注机油或黄油。起动发动机,待发动机作业平稳后,让插秧作业部件