产品风险评估报告一览表.docVIP

香港泰成玩具有限公司 Product Risk Assessment Form 产品风险评估一览表 PAGE 1 PAGE 1 Department Involved: RD Department (开发工程)/ Production Department (生产工程)、 Material Control Department (物料部)、Purchasing Department (采购部) 、Quality Department (品管部) Prepared by (组织人员) : Responsible Engineer (工程师) : Date (日期) : Item Name and No. (产品名称/编号) : Customer (客户) : Age Grade (适应年龄) ： Sale Region (销售地区) : (A) Mechanical (物理和机械性) No. Check Point Description评审项目 Result 评估结果 1 Sharp Point and Protruding parts (利角及突出物) (Puncture Hazard) ? Capable of causing punctures of the skin.（可导致刺伤皮肤） ? Check for existence of points with a cross section of 2 mm or less.（存在横截面等于或小于2mm的尖点） ? Check for existence of metallic wires and other metallic components that are designed and intended to be bent and metallic wires likely to be bent.（存在弯曲的金属线或其他金属组件） ? End protection should be given a sufficiently large surface area to avoid puncturing of the body.（末端应该覆盖足够大的表面积，避免刺穿。） 2 Sharp Edge (利边) Accessible edges that are likely to cause injury (no exposed sharp plastic or metal edges)存在可导致受伤的可接触边（需无批锋、金属边） 3 Small Part（小物件） (Choking, Ingestion and Inhalation Hazards) (3Y-)（窒息/吸入危害） Possibility of producing small parts when broken that fits completely into the small part test cylinder (dim. 31.7 mm) – eg. Wheels that come off cars, buttons and eyes that fall off dolls or plush toys.（产品存在可放入小物件筒的可拆卸物件、脱落物件。如：从车子上脱落的轮胎，从玩偶或毛绒玩具上脱落的纽扣和眼镜。） 4 Small Ball (Choking, Ingestion and Inhalation Hazards) (3Y-) Any ball that should not entirely passes through template E (dia. 44.5 mm).（任何球都不应该完全通过模板E）（直径.44.5mm） Housing for small ball/bead should have enough strength to withstand abuse test. 5 Suction Cup (吸盘) (3Y-) Shall not protrude past through template E (dia. 44.5 mm).（吸盘柄不可突出通过模板E） 6 Rattle, Squeeze toy, Teether or Hand-held activity toys (10M-) - EU No part of the toy (other than soft-filled part) shall protrude past the base of template A except the mass of the toy is greater than 0.5 Kg.（玩具部件不可突出通过模板A，除非玩具重量大于0