黄梅垃圾渗滤液处理方案.doc

Processing Technology of Ammonia Chemical Wastewater Ammonia wastewater has high ammonia and nitrogen, poor biodegradability, and is difficult to remove (COD ≤ 5000mg / L, ammonia nitrogen ≤ 2500mg / L, sulfide≤ 25 mg / L). The effluent after this treatment can achieve first class emission standards of the national Industrial Ammonia Water Pollutant Discharge Standards (GB13458-2001): COD ≤ 100 mg / L, ammonia and nitrogen ≤ 40 mg / L, SS ≤ 60 mg / L, cyanide ≤ 0.2 mg / L, sulfide ≤ 0.5mg / L, PH 6 ~ 9. Processes flow diagram: Process description: The high concentrated wastewater flow through grille to remove large scum, enters into high-efficiency clarifier to remove most of the suspended matters and then arrives into the oilseparating tank to remove most of the floating oil in the sewage. The effluent enters into gas-flocculation system, flocculant is added to remove suspended matter and oil in the water further. Precipitation flocs are removed in the vertical flow sedimentation tank and the pH is adjusted, and then ammonia is removed by entering into the ammonia and nitrogen desorption tower, after PH adjusting in a transition pool, wastewater enters into EGSB reactor for anaerobic biochemical treatment to remove organic matter from wastewater and improve biodegradability. The effluent would mix with light wastewater in the regulation tank and then to receive pretreatment in adsorption-sedimentation tank and enters into the A / O / A synchronized denitrification pool, the operation cycle is divided into anaerobic / aerobic / anoxic mode, in aerobic initial stage carbon source is dosed to make denitrifying bacteria have full storage of PHA polymer through its anabolic effect, in the subsequent stages of hypoxia, achieve high-efficiency denitrification effects, transform nitrate produced in aerobic stage into gaseous nitrogen, in order to achieve high-efficiency denitrification. And then the effluent runs into secondary sedimentation tank to achieve the so