材料与试验协会 B221M-2007 铝及铝合金挤压棒、线、型、管材检测标准（公制）.pdfVIP

Designation: B 221M – 07 METRIC Standard Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes [Metric]1 This standard is issued under the fixed designation B 221M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (e) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the Department of Defense. Note—Note 3 added and Sections 2.2, 9, X2.1, and Table 2 updated and the year date was changed on Aug. 10, 2007. 1. Scope* 2.2 ASTM Standards: 2 1.1 This specification covers aluminum and aluminum-alloy B 210M Specification for Aluminum and Aluminum-Alloy extruded bar, rod, wire, profile, and tube in the aluminum Drawn Seamless Tubes [Metric] alloys (Note 1) and tempers shown in Table 2. B 211M Specification for Aluminum and Aluminum-Alloy Bar, Rod, and Wire [Metric] NOTE 1—Throughout this specification the use of the term alloy in the B 241/B 241M Specification for Aluminum and Aluminum- general sense includes aluminum as well as aluminum alloy. Alloy Seamless Pipe and Seamless Extruded Tube NOTE 2—For rolled or cold-finished bars and rods refer to Specification B 211M, for drawn seamless tube used in pressure applications, Specifi- B 429/B