丰田普瑞斯 U660 E 自动变速器.ppt

* [ATF temperature check] (with Intelligent Tester) ATF温度检测(用智能检测仪) 1. Connect the Intelligent Tester.连接智能检测仪 2. Turn ON the TC terminal of DLC3 by active test.通过动作测试打开DLC3的TC端子。 3. Start the engine.起动发动机 4. Shift all position from P to S (1-6) range, and return to P range at engine idling and brake depressing. 发动机怠速并踩着刹车，换入从P到S(1-6)各档位置，再回到P档。 5. Shift alternately from N to D range position until “D” position indicator lights up. 换档杆在N和D位置交替切换，直到“D”档位指示灯闪。 Note: “D” position indicator lights up for 2 seconds, when transfer to the test mode. 注：当切换到测试模式时，“D”档位指示灯亮2秒。 6. Shift to P range and Turn OFF the TC terminal of DLC3. 挂到P档并关DLC3的TC端子。 7. Select the DATA LIST of the A/T. 选择 A/T中的DATA LIST 8. Warm-up the engine, and check that ATF is a proper temperature (40 - 45 °C [104 - 113 °F]). 发动机暖机，检查ATF正确的温度(40 - 45 °C [104 - 113 °F]). [ATF temperature check] (with Intelligent Tester) 1. Connect the Intelligent Tester. 2. Turn ON the TC terminal of DLC3 by active test. 3. Start the engine. 4. Shift all position from P to S (1-6) range, and return to P range at engine idling and brake depressing. 5. Shift alternately from N to D range position until the shift range indicator indicates “D” for 2 sec.. Note: When transfer to the test mode, the shift range indicator indicates “D” for 2 sec.. 6. Shift to P range and Turn OFF the TC terminal of DLC3. 7. Select the DATA LIST of the A/T. 8. Warm-up the engine, and check that ATF is a proper temperature (40 - 45 °C [104 - 113 °F]). * Adjust the ATF level调整ATF液面高度] In the test mode, the cooling fan is automatically operated to keep ATF in proper temp.. 在检测模式，冷却风扇会自动操作来保持ATF在正确的温度 And, the allowed working time for ATF adjustment is extended. (4 min. 20-60 min) 并且，ATF调节允许工作时间延长了(4分钟20-60分钟) Check that ATF is a proper temperature (D range indicator ON = 40 - 45 °C [104 - 113 °F]). 检查ATF工作温度正常。 2. Lift-up the vehicle with engine running. 发动机运转时升起车辆。 3. Remove the overflow plug. 拆下溢流塞 If ATF will overflows from overflow plug, wa