法兰盘说明书.docxVIP

摘　　要 本文的目的是对马达端盖钻孔进行设计机床液压传动、电气控制及工装设计。首先分析工件马达端盖的工序特点，加工精度，生产纲领，确定了采用组合机床来完成工件的批量夹具是机械加工不可缺少的部件，在机床技术向高速、高效、精密、复合、智能、环保方向发展的带动下，夹具技术正朝着高精、高效、模块、组合、通用、经济方向发展.通过老师的讲解和查阅各种相关资料，确定了机床的动作循环为“夹紧、快进、工进、死停、快退、松开和原位卸荷”。设计采用了一个变量泵供油的容积节流调速系统，这个系统实现了滑台快进时通过差动快进，快进和快退的速度相等。通过计算和查阅手册，计算和查出各个元件的型号和电机的型号。 通过老师的指导和查阅资料设计了梯形图和端子接线图以及主电路图。 在夹具设计阶段，本人对工件的加工工序进行了分析，最终考虑夹具设计的几点原则和注意事项，定下了工件的定位基准，采用一面两销定位方式。并确定了夹紧方向和夹紧力作用点。为了提高生产效率，最终确定了用液压夹紧的方式。 关键词：液压传动　　　　电气控制　　　　夹具设计  ABSTRACT The purpose of this paper is the electrical control and fixture design of hole processing machine tool hydraulic transmission, Machining fixture is an indispensable component, is developing toward high speed, efficiency, precision, complex, intelligent, environmental protection direction in machine tool technology driven, fixture technology is developing towards high precision, high efficiency, module, combination, general, economic direction. After the teachers explanation and access to all relevant information to determine the machine action cycle clamping, fast, stop, rewind, death, release and in situ unloading. The design uses a dual pump oil throttle speed control system this system realizes the slide forward through differential fast forward, fast forward and rewind equal speed. Through calculation and accessible handbook, calculation and found each element type and motor type. The ladder diagram and terminal wiring diagram and main circuit diagram design through teachers instruction and data access. In the fixture design stage, I am on the piece machining processes are analyzed, the fixture design several principles and the matters needing attention, set the piece positioning benchmark, using a two pin positioning method. And the action point clamping direction and clamping force. In order to improve production efficiency, and ultimately determine the hydraulic clamping way. Keywords: hydraulic drive electric control fixture design  目　　录 TOC \o 1-3 \h \z \u 1前　　言 1 2机床液压系统设计 2 2.1　液压