FILTRON反冲洗控制器手册 1-10- ENGLISH MANUAL.docVIP

PAGE PAGE PAGE 3 ISRAEL TALGIL COMPUTING CONTROL LTD. NAAMAN CENTER, HAIFA - ACCO ROAD 7000 P.O.BOX 775 KIRYAT MOTZKIN 26119, ISRAEL TEL: 972-4-8775947; 972-4-8775948 FAX: 972-4-8775949 E-mail: talgil33@netvision.net.il FILTRON 1-10 (DC/AC) U S E R S M A N U A L 2011 FILTRON 1-10 (DC/AC) List of features The “FILTRON 1-10” is a modular backflushing controller for automatic filters of 1 to 10 stations. There exist DC and AC models. The DC model can be powered either by 6v DC or 12v DC and it activates 2 wired 12v DC latching solenoids. The voltage for the solenoids switching is boosted by a charge pump. The AC model contains an internal transformer that can be powered by 110v or 220v from which it generates the 24v AC for the solenoids. Flushing cycles may be triggered either by time or by the embedded electronic DP sensor reaching the set point, or by a dry contact signal from an external DP sensor. Endless looping problems can be eliminated by detecting repeated consecutive cycles passing beyond a predefined limit. The unit can optionally handle a Pressure-Sustaining / Main valve, and an Alarm output. The unit is equipped with a customized LCD display and key board. The unit counts separately the number of flushing cycles triggered by DP, by time and manually. How to program the controller The controller is equipped with an LCD display and 4 keys as displayed below. When the unit is left untouched for a minute the display is switched off and the only life signal is given by a beep sound that can be heard every 20 seconds. Holding down any of the keys for a few seconds will bring the screen back to life. The DP The DP Set-Point. Available only when the built in electronic DP is used The Actual DP value. Available only when the built in electronic DP is used The desired flushing mode. Contains either the flushing interval or the letters “dp” when the flushing is triggered by dp only. The desired flushing mode. Contains either the flushing interval o