(美国材料实验协会 标准)A-S-T-M D473-2007(2017)e1.pdf

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. Designation: D473 − 07 (Reapproved 2017)´1 Manual of Petroleum Measurement Standards (MPMS), Chapter 10.1 Standard Test Method for Sediment in Crude Oils and Fuel Oils by the Extraction Method1 This standard is issued under the fixed designation D473; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the U.S. Department of Defense. ε1 NOTE—Footnote 1 was corrected editorially in August 2017. 1. Scope 2. Referenced Documents 1.1 This test method covers the determination of sediment 2.1 ASTM Standards:2 in crude oils and fuel oils by extraction with toluene. The D4057 Practice for Manual Sampling of Petroleum and precision applies to a range of sediment levels from 0.01 % to Petroleum Products (API MPMS Chapter 8.1) 0.40 % mass, although higher levels may be determined. D4177 Practice f