热力耦合 空腔辐射-ia.doc 11页

  • 0
  • 0
  • 0
  • 约1.62万字
  • 2020-01-25 发布
文档工具:
    1. 1、本文档共11页,可阅读全部内容。
    2. 2、本文档内容版权归属内容提供方,所产生的收益全部归内容提供方所有。如果您对本文有版权争议,可选择认领,认领后既往收益都归您。
    3. 3、本文档由用户上传,本站不保证质量和数量令人满意,可能有诸多瑕疵,付费之前,请仔细先通过免费阅读内容等途径辨别内容交易风险。如存在严重挂羊头卖狗肉之情形,可联系本站下载客服投诉处理。
    4. 文档侵权举报电话:19940600175。
    PAGE 12 W REF workshopnumber \h W REF workshopnumber \h 2.PAGE 7 Copyright 2006 ABAQUS, Inc. REF coursetitle \h Heat Transfer and Thermal-Stress Analysis with ABAQUS Workshop 2 Radiation in a Finned Surface Interactive Version Copyright 2006 ABAQUS, Inc. Heat Transfer and Thermal-Stress Analysis with ABAQUS Note: This workshop provides instructions in terms of the ABAQUS GUI interface. If you wish to use the ABAQUS Keywords interface instead, please see the “Keywords” version of these instructions. Please complete either the Keywords or Interactive version of this workshop. Goals When you complete this workshop you will be able to: Apply thermal initial conditions for temperature. Define thermal material properties. Specify boundary conditions to regions with known temperature distributions. Specify film boundary conditions. Define cavity radiation properties. Plot and animate contours of the temperature distribution, and plot the temperature history of selected points in the fin. Figure W2– SEQ Figure_W2- \* ARABIC 1 Plane finned surface. Introduction This workshop illustrates the ABAQUS capability to solve heat transfer problems including cavity radiation. We simulate the effects of a fire condition on a plane finned surface. The configuration shown in Figure?W2–1 represents a plane wall with a uniform array of parallel rectangular fins attached. The problem represents three phases in a fire test: The first is the pretest, a steady-state condition where heat is transferred by natural convection from an internal fluid at a fixed temperature of 100°C to the plane inside wall. Heat is conducted through the wall and dissipated by radiation and natural convection from the outside wall and fin surfaces to the surrounding medium, which is at a temperature of 38°C. The second phase is a 30-minute fire transient, where heat is supplied by radiation and forced convection from a hot external fluid at 800°C. After conduction through the fins and wall, heat is reje

    文档评论(0)

    • 内容提供方:138****3419
    • 审核时间:2020-01-25
    • 审核编号:7050022131002113

    相似文档