AASHTO T23-2008 国外国际标准.pdfVIP

Standard Method of Test for Making and Curing Concrete Test Specimens in the Field AASHTO Designation: T 23-081 ASTM Designation: C 31-06 1. SCOPE 1.1. This method covers procedures for making and curing cylinder and beam specimens from representative samples of fresh concrete for a construction project. 1.2. The concrete used to make the molded specimens shall be sampled after all on-site adjustments have been made to the mixture proportions, including the addition of mix water and admixtures. This practice is not satisfactory for making specimens from concrete not having measurable slump or requiring other sizes or shapes of specimens. 1.3. The values stated in SI units are to be regarded as the standard. 1.4. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to exposed skin and tissue upon prolonged exposure. 2. REFERENCED DOCUMENTS 2.1. AASHTO Standards : M 195, Lightweight Aggregates for Structural Concrete M 201, Mixing Rooms, Moist Cabinets, Moist Rooms, and Water Storage Tanks Used in the Testing of Hydraulic Cements and Concretes M 205M/M 205, Molds for Forming Concrete Test Cylinders Vertically R 39, Making and Curing Concrete Test Specimens in the Laboratory T 119M/T 119, Slump of Hydraulic Cement Concrete T 121M/T 121, Densit