NFPA58ERTA1-2010 国外国际标准.pdfVIP

Errata NFPA 58 Liquefied Petroleum Gas Code 2011 Edition Reference: Entire Document Errata No.: 58-11-1 The Technical Committee on Liquefied Petroleum Gases notes the following errors in the 2011 edition of NFPA 58, Liquefied Petroleum Gas Code . 1. Replace the term “piping system” with “fixed piping system” in 3.3.23, , (A), 6.8.2, and 6.8.2(A) and 6.8.2(B). 2. In Table , the “less than or equal to” sign in front of 626, first item in the second column, should be deleted. 3. Revise (2) to read as follows: (2) If temperature correction markings are provided on variable liquid level gauges on containers greater than 1200 gal (4.5 m3) that will be used for volumetric filling as allowed by (A), (B), and , the markings shall indicate the maximum liquid level at liquid temperatures in accordance with Tables (b) or (c) Table (b) or Table (c). Temperature markings shall be from 20°F to 115°F (−6.7°C to 46°C), with increments not to exceed 20 F° (11.1°C) for propane, for 50/50 butane-propane mixtures, and for butane. 4. Revise the notes to Table 6.3.1 as follows: b See 6.3.11 c See 6.3.10 e See 6.3.7 and 6.3.8 (Notes a, d, and f are OK as is) 5. Revise (1) to read as follows: (1) Regulators on cylinders installed indoors in accordance with Section 6.17 6.19 6. Revise to read as follows: Where a container is transported with more LP-Gas than 5 percent of its water capacity in a liquid form, all of the following conditions shall apply: (1) The maximum filling does not exceed the container shall not be filled beyond the filling limit of Section 7.4. 7. In , change 3 to 4. 8. In Figure I.1(a), make the following changes: Add to Note 1: “Refer to Table 6.3.8.” Change the callout to the manifold cylinder