西门子WinCC与HMI人机界面_图文.doc

WinCC 與HMI 人機介面 1. 在Plant View 視窗下,點選欲新增人機介面之區域, 按滑鼠右鍵-Insert New Object -Picture ,新增一圖片 2. 輸入圖片名稱 1. Click right key of mouse 2. Select Insert New Object 3. Select Picture Key in the name of picture 3.在Component view視窗下,點選ES-WinCC Application-OS 在OS上按滑鼠右鍵-Open Object 1.Click right key of mouse 2.Select Open Object 4.點選Computer,在右方視窗電腦名稱上按右鍵-Properties 2.Click right key of mouse 3.Select Properties 1.Select Computer 5.輸入該部電腦的實際Computer Nam e,按OK返回 1.Key in the Computer Name same as your computer 2.Click OK 6.滑鼠左鍵雙擊OS Project Editor Double click left key of mouse 7.進入OS Project Editor畫面後,選取上方Layout標籤,並選取螢幕解析度與數量 1. Select Layout 2. Select screen resolution 3. Select monitor configuration 8.按OK確認 Click OK 9.返回Component視窗,點選ES-WinCC Application-OS 在OS上按滑鼠右鍵-Compile 3. Select Compile 1. Select ES 2. Click right key of mouse 10.按Next進行下一步 Click Next 11.若系統架構中含有多個操作站,則可在此選擇將圖片指向哪一個操作站 選擇完成後按Next 12.按Connection 1. Select Station 2. Click Next 1. Click Connection 2. Click Next 13.進入Select Network Connection畫面後,點選S7 connection,按OK確定後跳出, 按Next進行下一步 1.Select S7 Connection (when adopt OS+CP1613 2. Click OK 14.D ata:勾選Tags and messages與Picture Tree Scope:點選Entire OS,並勾選With memory reset Minimum acquisition cycle of the archive tag s:依需求設定,預設為1秒 設定完成後按Next (第二次OS Compil e不必勾選Picture Tree 5. Select 1 second 1. Select Tags and messages 2. Select Picture Tree 3. Select Entire OS 4. Select With memory reset 6. Click Next 15.按Compile Click Compile 16.C ompile執行中 完成OS Compile後,PCS7會自動將程式中的OP_D、OP_A、DIG_MON、 MEAS_MON等Block以內建物件自動轉換至人機介面 更改內建Faceplate物件 1.程式編輯時,使用OP_D This is a OP_D block 2.在該Block上按滑鼠右鍵-Object Properties 1. Click right key of mouse 2. Select Object Properties 3.進入後可見Create block icon有打勾,但底下欄位空白,表示其採用內建Faceplate 4. 程式編輯完成後,執行 OS Compile Here is empty So use default faceplate Click OK 5.OS Compile完成後打開該程式人機介面圖檔 Double click the picture 6.圖片開啟後可見其OP_D內建Faceplate Default OP_D faceplate 7.如須依使用者須求更改內建Faceplate,則先開啟WinCC Application 1. Click right key of mouse 2. Select O