双极非线性元件特性曲线之简单测.doc

双极非线性元件特性曲线之简单测 ????1实验三 双极非线性元件特性曲线之简单测 实验目的: 学习使用同轴测试棒(cable),探针(probe),并将其与示波器,双极非线性元件组合成测试电 后,将示波器设定在X-Y 模式(X-Y mode),并且测 一些双极非线性元件之特性曲线. 实验仪器: 1. 双极非线性元件: (1). 矽二极体(Silicon Diode) (2). 锗二极体(Germenium Diode) (3). 齐纳二极体(Zener Diode) 2. out, the duty cycle is adjustable between 20% and 80%, and the output frequency is unchanged. 6. ATTENUATION When this push button is out, the signal is passed to the output unchanged. If the switch is depressed, the output signal is attenuated by -30dB. 7. DC OFFSET This knob allows a variable DC voltage between -10V to +10V to be added to the output signal. Note that the knob has to be pulled out for the offset to affect the signal. When the knob is pushed in, no offset voltage is added. 8. OUTPUT This BNC connector provides the output signal for all waveforms. 9. POWER ON This is the main power switch. It is a push on / push off type. 10. SWEEP WIDTH 10.1 Sweep width can be controlled from 1 to 1000 times. 10.2 When this knob is pushed in, the sweep is in LINEAR mode. When pulled out, the sweep is in LOG mode. 11. SWEEP RATE 11.1 When switch off, there is no sweep function. 11.2 When switch on, the sweep rate can be adjusted from 10mS to 5S. 12. FUNC I COUNT When the switch is out, the 6 digits DISPLAY (13) shows the generator frequency. When the switch is in, the DISPLAY (13) shows the input frequency of counter. 13. FREQUENCY DISPLAY This is a 6-digit 7-segment LED display that shows the output frequency of the main generator or the input frequency of the counter. 14. INDICATORS OVFL, GATE, KHz, Hz LEDs indicate frequency overflow, gate time and frequency units in KHz, Hz. 15. SYNC OUT This connector supplies a TTL compatible signal. The output is unaffected by either the FUNCTION (2) or AMPLITUDE (1) controls. The output frequency is the same as the of OUTPUT signal (8). 使用时请注意: 1. To assure operation within the published specifications, allow theunit to w up and stabilize for at