【环境工程专业】【毕业设计 文献综述 开题报告】厌氧—好氧生物转盘法处理2500m3d印染废水工艺设计.doc

【环境工程专业】【毕业设计+文献综述+开题报告】厌氧—好氧生物转盘法处理2500m3d印染废水工艺设计 （20届） 毕业论文 出水水质达到纺织漂染工业废水污染物排放级关键词:印染废水厌氧好氧处理 Abstract: The printing waste water has the water volume to be big, chromaticity deep, organic pollutant content higher characteristic is one which of waste water in our country industrial waste is difficult to govern. If therefore the printing waste water after the government direct platoon, will not have the serious influence to the ground water body, causes in the water body the ecosystem destruction and the water body is corrupt, thus creates the ecological damage and the economic loss are inestimable. This design uses the processing craft carries on processing for the anaerobic - good oxygen rotating contactor law to this kind of waste water. This craft use anaerobic microorganism to the organic matter which difficult to degrade decomposes first into the simple small molecular organic matter, then carries on the oxygen biological treatment again using the rotating contactor, can in effective elimination water COD, BOD5, SS and the chromaticity and so on. Moreover this craft's power consumption are few, therefore the operating cost is low, the water leakage water quality is stable. The water leakage water quality achieves the textile bleaching and dyeing industrial waste pollutant dischargeⅠLevel. Keywords: Printing waste water ；anaerobism -oxygen dealing；process design 目 录 摘要 Ⅰ Abstract Ⅱ 1 绪论 1 1.1 印染废水的产生 1 1.1.1 前处理产生的废水 1 1.1.2 染色和印花废水的产生 1 1.2 印染废水的特点 2 1.3 印染废水的危害 2 1.4 设计任务书 2 1.4.1 设计题目 2 2 废水的处理方案和工艺流程 4 2.1 废水性质 4 2.2 方案选择 4 2.2.1 A/O工艺 4 2.2.2 吸附-生物降解工艺 5 2.2.3 膜生物反应器 5 2.3 工艺流程 6 3 各种构筑物的设计说明与计算 7 3.1 格栅 7 3.1.1 格栅的设计参数 7 3.1.2 各部分具体计算 7 3.1.3 格栅示意图 9 3.1.4 格栅机的选型 9 3.2 调节池 9 3.2.1 加酸中和 9 3.2.2 池体体积计算 10 3.3 鼓风机的选型 11 3.4 泵房 12 3.4.1 集水间计算 12 3.4.2 水泵总扬程计算 13 3.4.3 水泵机组基础计算 13 3.4.4 校核扬程 13 3.5 水解酸化池 14 3.5.1 介绍 14 3.5.2 体积算 14 3.5.3 水配水系统 15 3.6 生物转盘的设计 16 3.7 二沉池的计算 18 3.7.1 二沉池参数计算 18 3