集成化、通用性系统仿真器TRACE32排故介绍.pdf

TRACE32®工具使用中的 Troubleshooting Frank Xing• frank.xing@ • September 17, 2019 Agenda • Connection Failed • HLL Symbol Loading Failed • Linux Awareness Failed • Hypervisor System 17/9/2019 2 / 46 Connection Problem 17/9/2019 3 / 46 Target Power Fail • Target board not properly powered • It’s an electrical problem, verify the wires • Verify that the power is working • Ideas: • Check if the VCC pin on the debug connector is powered (without and with debug cable connected) • Check if VREF-DEBUG not properly connected to the JTAG connector • Check if the debug connector pins are correctly connected 17/9/2019 4 / 46 Debug Port Fail • Possible causes: • Core kept in reset, has no clock, has no power, secured? • JTAG port muxed and wrong mode selected • Debug cable connected to the wrong connector • Wrong jumper settings • Wrong power supply • Bad wiring (self made adapter/flying wires..) • Watchdog 17/9/2019 5 / 46 Debug Port Fail • Try with different debug port configurations in SYStem.CONFIG window 17/9/2019 6 / 46 Debug Port Time-out at <address> • Possible Causes: • TrustZone device: • Debugging in secure