PPT创意设计方案9.1.ppt

2007 The conception of XTP was put forward by IHEP; 2008-2012 An advanced research of the XTP was carried out by ISSE; 2013-2014 Completed the system analysis and achieved the mission’s basic parameters . The first step design of the XTP was finished; 2015-2016 With the LAD and WFM adding into the XTP and the parameters of SFA&PFA has changed，redesigned the eXTP satellite; 2017 New launch vehicle; new orbit；new payload；So we update the design of the eXTP satellite. ;3. Basic Parameters;LM-7 launch vehicle ，has a big fairing with diameter of 4200mm a total height of 10300 mm， has maximum capacity for 550km circular orbit at 0 deg. inclination is 4500kg.;The –X axis point to the specific objects in the inertial space ； The sun vector is controlled in XOZ plane and in a obtuse angle with the +Z axis； The sun vector will perpendicular to the solar array by rotate it； According to the user’s observation plan to carry out attitude maneuver，aiming at the burst objects to carry on the observation.;;;4. Preliminary Design;Service module(SVM): the SVM includes all units required to control and operate the S/C platform. The WFM and GRM are accommodated in the SVM, too. LAD Assembly(LADA): the LADA consists of LAD panel(#1~#4), LAD sunshields, deployment mechanisms. The LADA are accomodated on either sides of the SVM. Mirror Assembly Module(MAM): the MAM is located inside the telescope tube , contains the SFA & PFA mirror module and star trackers，with the associated supporting platform. Telescope Tube(TT): the TT allows to maintain the SFA&PFA at the required distance from the focal planes. Focal Plane Assembly (FPA) : the FPA hosts the 13 focal plane cameras, including thermal control hardware. ;4. Preliminary Design;4. Preliminary Design;;4. Preliminary Design;4. Preliminary Design;4. Preliminary Design;4. Preliminary Design;4. Preliminary Design;Phase A:2017.01~2017.12, international coordination, feasibility design ~2017.08, S