风机结构原理及控制系统.ppt

Vestas Wind Systems A/S GB903-003-V90-WTG installation * Purpose: Explain the difference between vertical and horizontal alignment Notes: The simulation is to show that the alignment can be up or down or in an angle compared to each other. Tolerances can be found in the service documentation. The simulator illustrates how the alignment exceeds tolerance limits Vestas Wind Systems A/S GB903-003-V90-WTG installation * Purpose: Explain how to align the V82 generator left or right Notes: Adjustable generator foot. Can be adjusted up or down. A tool must be used for sideways adjustments. The generator position must be adjusted if the shaft alignment is outside the given tolerances. The complete work instruction can be found in the service manual Vestas Wind Systems A/S GB903-003-V90-WTG installation * Purpose: Explain how to align the V82 generator up or down Notes: The adjustment of the generator is done by lifting the generator with a pump and a piston, shims are used to lower or raise the height. A tool must be used for sideways adjustments. The generator position must be adjusted if the shaft alignment is outside the given tolerances. The complete work instruction can be found in the service manual Vestas Wind Systems A/S GB903-003-V90-WTG installation * Purpose: Explain the naming of the gear wheels. Notes: Vestas Wind Systems A/S GB903-003-V90-WTG installation * Purpose: Explain the different types of bearings, which are normally used in the gearbox. Notes: The type of bearings which are normally used can be various according to the type and manufacturor. Vestas Wind Systems A/S GB903-003-V90-WTG installation * Purpose: Explain the oil pump of the V80 gearbox Notes: The pump is an internal gear pump driven by the high speed shaft of the gearbox and thus delivers oil anytime the drive train is in rotation. Depending on the gearbox type the pump flow will be: V80 VCS Hansen gear, 50 Hz 1680 rpm 50 L min. V80 VCS L&S gear, 50 H 1680 rp