发电机安装使用维护说明书 英文.docVIP

Sondu/Miriu Hydropower Project Sang’oro Power Plant Contract. No. SDM08 Employer KENGEN Engineer Nippon Koei Co.,Ltd. Contractor Sinohydro Corporation Ltd. Document No. MD-06-B2-05-004 (R1) Page (s) 5 Date 16th Mar 2011 OPERATION AND MAINTENANCE MANUAL OF GENERATOR (Lot AP-2) R1 16th Mar 2011 1st Submission REV. DATE PREPARED CHECKED ENDORSED APPROVED Description Format : A4 1 Operation of generator 1.1 Preparations before start-up, including: a) Clean the work-yard and the generator set from any debris. b) Check the tightening condition, lock the gasket tightly, tack weld if necessary; keep the rotatable parts clean. c) Check the inlet and outlet water pipelines, oil pipelines and valves, in order to know if there are leakages and problems of water flow in the pipe. d) Check the level of lubricating oil, oil number, oil quality, water pressure, and record the water temperature and ambient temperature. e) Check each connecting cable, to make sure that the joints contact well and without rust, connection is right, and the marks are complete and distinct. f) Check if the equipments of high-pressure oil and the brake run normally, and if the brake pressure can meet the relevant requirements. g) Check the fire extinguishing system and other protecting facilities, to ensure security. h) Check the gaps between rotating parts and stationary parts, especially when there are dimension requirements. i) Make preparation work of recording before start-up. 1.2 Initial no-load start-up operation The time of initial start-up of generator, operating sequence and the general commander shall be determined through consultation among the buyer, the seller and the installation entity. 1.2.1 Under the organization of the general commander, the operators and monitors shall get 1.2.2 Before start-up, first open the cooling water of the upper and lower oil cooler and air cooler. The temperature of the oil in the oil tank shall not be lower than 100C, and that in the plas