微软认证模拟试题 TCP IP考题.docVIP

微软认证模拟试题 TCP IP考题 Question 1. Under Windows NT, what mand would you use if you wanted to trace a packet from its source host to a destination host? A. TRACERT B. ROUTE C. NBTSTAT D. IPCONFIG The TRACERT utility is Microsoft's own, used to trace a packet from its source ( your puter ) to a destination host ( a remote puter ). Question 2. If you wanted to display all entries in the ARP cache, which of the following utilities would you use? A . ARP - G B. ARP - E C. ARP - D D. ARP - S To display all entries in the ARP ( Address Resolution Protocol ) cache, you would use the ARP utility with the -G or - A switch. They are the same thing. To get the answer type "arp /?" at the mand prompt. ARP ( Address Resolution Protocol ) is used to obtain hardware ( MAC = Media Aess Control ) addresses for munications with a destination host. Question 3. You notice that the sub mask is on your Windows NT puter while using the IPCONFIG utility at the mand prompt to check for IP address configuration. What does it mean when the IPCONFIG utility displays a sub mask of ? A. The default gateway on your puter does not match the default gateway of the work. B. Your puter has the same sub mask as another puter on the work. C. Your puter does not have the correct IP address class specified for it. D. Your puter has the same IP address as another puter on the work. The most likely cause in this scenario is that your puter has the same IP address as another puter in the work. When this happens, running IPCONFIG will yield an IP address of . Question 4. If you want to copy files from one Windows NT puter to another, what TCP / IP utility would you use? A . RCP B. REXEC C. TELNET D. TRACERT The RCP ( Remote Copy ) is Microsoft's own TCP / IP utility. It is used to copy files from a source Windows NT puter to a destination ( remote ) Windows NT puter, or vice-versa. Type "rcp /?" at the mand prompt to get the mand's full syntax. Question 5. Use the following diagram to a