06-接口管理命令参考-接口批量配置命令.pdfVIP

目 录 1 接口批量配置 ················································································································ 1-1  1.1 接口批量配置命令 ······································································································· 1-1  1.1.1 display interface range ························································································ 1-1  1.1.2 interface range ·································································································· 1-1  1.1.3 interface range name·························································································· 1-3  i 1 接口批量配置 1.1 接口批量配置命令 1.1.1 display interface range display interface range 命令用来显示通过interface range name 命令创建的批量接口的信息。 【命令】 display interface range [ name name ] 【视图】 任意视图 【缺省用户角色】 network-admin network-operator context-admin context-operator 【参数】 name name ：设备上已创建的批量接口的别名，为 1～32 个字符的字符串，区分大小写。不指定 该参数时，显示当前设备中所有已创建的批量接口的信息。 【举例】 # 显示当前设备中所有通过interface range name 命令创建的批量接口的信息。 Sysname display interface range Interface range name t2 gigabitethernet1/0/1 gigabitethernet1/0/2 Interface range name test gigabitethernet1/0/11 gigabitethernet1/0/12 以上显示信息表明：批量接口t2 下绑定了接口GigabitEthernet1/0/1 和GigabitEthernet1/0/2，批量 接口test 下绑定了接口GigabitEthernet1/0/11 和GigabitEthernet1/0/12。 【相关命令】 • interface range name 1.1.2 interface range interface range 命令用来绑定一组接口，并进入接口批量配置视图。 【命令】 interface range interface-list 【视图】 系统视图 1-1 【缺省用户角色】 network-admin context-admin 【参数】 interface-list ：接口列表，表示方式为 interface-list ＝ { interface-type interface-number [ to interface-type