思科n7k端口监听配置.docVIP

b)? ? ? ? Cisco nexus系列交换机（N7K）端口监听配置Switchport Analyzer(SPAN)：SPAN 可被用于给源端口到目的端口的流量做一个镜象流量，以便提供给数据包分析器或对住机的具体应用和故障排除分析器进行管理。?A SPAN的目标接口需要配置成switchport monitor接口，同时进程应处于active状态。1. 配置目标SPAN 接口:n7000(config)# interface ethernet 2/14n7000(config-if)# switchportn7000(config-if)# switchport monitor（配置目标monitor接口）2.端口镜像配置：n7000(config)# monitor session 1n7000(config-monitor)# description Inbound(rx)/both SPAN on Eth 2/13n7000(config-monitor)# source interface ethernet 2/13 rx/both(配置源monitor接口)?n7000(config-monitor)# destination interface ethernet 2/14?n7000(config-monitor)# no shut(激活镜像)3.验证SPAN①验证目标接口类型：n7000# show interface ethernet 2/14Ethernet2/14 is up??Hardware is 10/100/1000 Ethernet, address is 001b.54c0.fedd (bia 001b.54c0.fedd)??MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,? ???reliability 255/255, txload 1/255, rxload 1/255??Encapsulation ARPA??Port mode is access??full-duplex, 1000 Mb/s??Beacon is turned off??Auto-Negotiation is turned on??Input flow-control is off, output flow-control is off??Auto-mdix is turned on??Switchport monitor is on（交换接口模式）??Last clearing of show interface counters never②验证SPAN进程n7000# show monitor session 1? ?session 1---------------description? ?? ? : Inbound(rx) SPAN on Eth 2/13type? ?? ?? ?? ???: localstate? ?? ?? ?? ? : up（运行的监控进程为UP）source intf? ?? ? :?? ? rx? ?? ?? ?? ?: Eth2/13? ?（源接口=rx或both等）? ? tx? ?? ?? ?? ?:?? ? both? ?? ?? ? :?source VLANs? ?? ?:?? ? rx? ?? ?? ?? ?:?? ? tx? ?? ?? ?? ?:?? ? both? ?? ?? ? :?filter VLANs? ?? ?: filter not specifieddestination ports : Eth2/14? ?（目标接口）