ja-3安全阀说明书.doc08.8.2.docVIP

JA-3剪销安全阀 JA-3 SHEAR RELIEF VALVE 使用说明 Operation Introduction JA-3剪销安全阀 JA-3 Shear Relief Valve JA-3剪销安全阀法兰接头 JA-3 Shear Relief Valve Flange Union Joint  Item No. (1) (2) (3) (4) (5) (6) 规格说明Description 接头 Union Joint 挡圈 Snap Ring 活塞总成Piston assy. 阀体 Valve Body 活塞杆 Piston rod 缓冲垫 Cushion pad Item No. (7) (8) (9) (10) (11) (12) 规格说明Description 圆柱销 Column pin 缩紧弹簧 Lock spring 安全盖 Safety cover 剪切板 Shear board 剪切销 Shear pin 警告牌 Warning plate Item No. (13) (14) (15) (16) (17) (18) 规格说明Description 销轴 Pin shaft 钢丝挡圈 Steel wire snap ring 铭牌 Name plate 销轴 Cotter pin 螺母 Nut M4 螺钉 Screw nail M4×16 Item No. (19) (20) (21) 规格说明Description 螺栓 Bolt M10×110 螺母 Nut M10 螺栓 Screw nail M3×8 法兰接头 Flange Union Joint JA-3剪销安全阀结构如上图所示。当压力高出额定知时，（3）活塞升起，顶起剪切板（10）以剪短剪切销（11）从而快速排空压力。 JA-3剪销安全阀靠改变剪切销的位置进而达到排出压力的效果，操作简单。 所标示的压力被可在剪切板上。当要调节压力时，只要把剪切销插到相对应的孔里即可。注意，一个剪切销只允许插入一个剪切板中。缸套尺寸同剪销安全阀压力变化相关。禁止使用铁丝，焊条或替他物质代替。那将安全阀压力受到影响而引发事故。 The structure of JA-3 shear relief valve is showed above. When the pressure is more than the rated data, the piston⑶ raises, jacks up the shear board⑽ to break off the shear pin⑾ so as to empty the sap flow promptly. JA-3 shear relief valve change the leaked pressure with the poison movement of shear pin. It operates simply. Pressure level mark is carved on the shear board. You only need insert the shear pin into the relative hole when you want to adjust the operation pressure. Note, only one shear pin is allowed to insert in shear board. Liner size is changed relatively adjust the relief valve pressure. The use of steel wire, welding rod or other materials is forbidden. That will effect pressure of relief valve and cause the accident.