PC200-8 New Product_Service Training_s 挖机 技术资料.ppt

Cooling PC200-8 PC200-7 Change in Cooling Radiator Oil cooler After cooler Condenser of air conditioner Fuel cooler Radiator Oil cooler After cooler Condenser of air conditioner Oil cooler is 3-piece assembly Pilot check valve:To be contained in the control valve from Model 8 Receiver dryer has a combined type structure(The same structure as PC228US-3) Electrical equipment on Machine Body Change in harness Change in clip Colgate clip (resin) Inside the CAB Outside the CAB Divided by connectors To sensors on the machine body To controller and monitor Inside the CAB Outside the CAB All connectors were abolished and replaced with harnesses To sensors on the machine body To controller and monitor PC200-8 PC200-7 PC200-8 PC200-7 Electrical equipment on Machine Body Change in travel alarm Reduction in size of travel alarm PC200 107dB　　　　　　　　　　　　　　　　　　　　 PC220 107dB Improved safety of power supply circuit Employment of independent power supply circuit (Single line) Heat-resistant conduit and tape are used Alternator Alternator Signal and power supply circuit (united) Ordinary conduit and tape are used Model 8 PC200 97dB　　　　　　　　　　　　　　　　　　　　 PC220 107dB　 Model 8 Model 7 Model 7 Electrical equipment on Machine Body Pressure sensor Change in high-pressure sensor Six low-pressure sensors have been employed for PPC circuit ? Current: Pressure switch Change in connector 　　AMP EJ II (3-pole) ? DT (3 pole) Connector: AMP EJ II (3-pole) Hydraulic Equipment and Pipe related Changes Overview of Hydraulic Equipment and Pipe related Changes PPC circuit: Pressure sensor ? Pressure switch New junction valve EPC valve has been employed for the control of converging and dividing of main and LS (currently the control is done by ON or OFF of the solenoid valve) Employment of control valve-contained cooler check valve Hydraulic Equipment and Pipe related Changes Overview of Hydraulic Equipment and Pipe related Changes Employment of the arm quick return valve Changes in the cont