(完整版)锂电池英文生产流程.docxVIP

Mixing( 配料 )Mix solvent and bound separately with positive and negative active materials. Make into positive and negative pasty materials after stirring at high speed till uniformity.Coating （涂布）Now, we are in coating line. We use back reverse coating. This is the slurry-mixing tank. Theanode（ Cathode） slurry is introduced to the coating header by pneumaticit Mixing( 配料 ) Mix solvent and bound separately with positive and negative active materials. Make into positive and negative pasty materials after stirring at high speed till uniformity. Coating （涂布） Now, we are in coating line. We use back reverse coating. This is the slurry-mixing tank. The anode（ Cathode） slurry is introduced to the coating header by pneumaticity from the mixing tank. The slurry is coated uniformly on the copper foil, then the solvent is evaporated in this oven. （下 面的依据情形而定） There are four temperature zones, they are independently controlled. Zone one sets at 55 degree C, zone two sets at 65 degree C, zone three sets at 80 degree C, zone four sets at 60 degree C. The speed of coating is 4 meters per minute. You see the slurry is dried. The electrode is wound to be a big roll and put into the oven. The time is more than 2 hours and temperature is set at 60 degree C. Throughout the coating, we use micrometer to measure the electrode thickness per about 15 minutes. We do this in order to keep the best consistency of the electrode. Vocabulary: coating line Al/copper foil back reverse coating degree C 摄氏度 coating header 涂布机头 temperature zones 温区 oven 烘箱 涂布车间 铝/铜箔 辊涂 wind to be a （ big ） roll evaporate 蒸发 evenly/uniformly electrode 极片 Cutting 收卷 匀称 Cut a roll of positive and negative sheet into smaller sheets according to battery specification and punching request. Pressing Press the above positive and negative sheets till they become flat. Punching Punching sheets into electrodes according to battery specification, Electrode After coating we compress the electrode with this cylindering mach