20141205 紫外线杀菌器UV探头 Field Service report Nestle Pudong 22th Nov 2014 signed.pdf

FIELD SERVICE – Service Report SERVICE REQUESTED: START UP INSPECTION SERVICE WARRANTY PO# : HPW SO# : 137126 DATE : 22th Nov 2014 CUSTOMER CONTACT INFORMATION CUSTOMER : HPW CUSTOMER NO : 6928 CUSTOMER PHONE: CUSTOMER E-MAIL: SITE CUSTOMER : TechLong SITE CONTACT : Mr Kou SITE E-MAIL : SITE PHONE : SITE ADDRESS : Nestle Pudong NAME PLATE INFORMATION (LOCATED ON UV TREATMENT CHAMBER) UNIT SERIES MODEL # : 08AL30#24667 PROJECT/SERIAL # : 162226 MFG. Date : 2013 SO # : 137126 PROBLEMS REPORTED st New sealed sensor #1 ( stainless steel body) was installed on 21 Sep 2014 but found not working properly after a few th days. The UV intensity kept showing zero even the lamps are turned on. Re-visited site on 30 Sep 2014 to check on the faulty sealed sensor #1. After troubleshooting, confirmed sealed sensor #1 was bad. Due to production, I am not able to replace the faulty sensor and therefore replacement sealed sensor #2 was handed over to TechLong engineer Mr Tang. He will install sealed sensor #2 when there is no production. A few weeks later, another problem was reported that sealed sensor #2 was showing full scale UV intensity reading even the lamps are off. 新式密封传感器＃1 （不锈钢体）2014 年9 月21 日 （周日）安装，但几天后发现不正常。UV 光强度一直显示在零即使所有灯管正常运行。 2014 年9 月30 日 （周二）再次到现场去检查设备，故障排除后，新式密封传感器＃1 （不锈钢体）确实故障。由于当时正在生产，没能更换 新式密封传感器＃1 （不锈钢体），因此更把新式密封传感器＃2 交给TechLong 现场工程师唐安奋先生。唐工将在下次停产时把新式密封传感器 ＃2 换上。