珍珠控台编辑修改单步程序详细教程.docVIP

珍珠控台编辑修改单步程序详细教程 一、复制一个场景 模拟珍珠控台需要设置热键: Optinos--Setup Hotkeys 复制一个场景方法一、复制一个链接拷贝场景: 新的场景是链接到旧的场景的一个拷贝，如果你更改连接的场景，所有其他连接到它的场景也会改变。 如果你已经命名了复制的场景，链接场景就会是相同的名字，如同影印了这个场景一样。(例如:要把重放区的第15推杆上的程序复制到第14推杆上) 1.按住想要复制的第15推杆上的程序 的Flash按钮。 2.再同时按想要存储的第14推杆上的重放Swop按钮。显示屏显示:Hit a playback swop to make a link (即单击一个重放swop键，建立一个关联)。 3.然后全部松开第14推杆上的Swop按钮和第15推杆上的Flash按钮。 重放区的第15推杆上的程序就复制到第14推杆上。 medium above the surface of the pipe and heat, and their spacing is greater than 150mm. Tubing when laid horizontally, should according to different requirement of the 1:10~1:100 slope, tilt should be guaranteed to exclude gas or condensate. 5.1.7.5 angle and u-tube for pressure pipe cards, isolation with a rubber plate, bracket horizontal laying spacing for the 1~1.5M, vertical laying spacing for the 1.5~2m. 5.1.7.6 after you finish laying tubing, should be blowing and pressure testing, air tightness test. 5.1.8 gas pipe laying 5.1.8.1 gas supply system using pipes, valves, fittings, cleaning should be carried out prior to installation, there should be no oil, water, corrosion and dirt. 5.1.8.2 air tubes after cutting, remove end of iron, smooth polished pipe end. Threaded connections, not seal welded, sealed with Teflon tape. Terminal Connection pipes should have a sufficient number of allowances, reduce the effects of vibration and stress. 5.1.8.3 air tube should be used to pipe rack, suitable structures, non-removable device support, terminal be fixed firmly in the 0.9m, bracket 2m. Pipe is not supported on device or process piping: might move or motion of an object, such as heat exchangers, control valves; diameter 3 pipe, insulation pipe liquid pipe, 1000C, high temperatures of over. 5.1.8.4 dismantling the pipeline in place, should provide a Union. Laid in each pipe, should be installed at least and the possible number of fittings. Perpendicular to the long end of the gas in the pipeline should have a drain valve. 5.1.9 field instrument installation 5.1.9.1 General requiremen