电波暗室辐射场抗扰度场地均匀性校准规程.docVIP

技 术 文 件 3m法电波暗室辐射场抗扰度场地均匀性校准规程 The method of uniform field strength calibration in 3m chamber 第一版 The 1st edition 批准： 日期： 审定： 日期： 编制： 日期： 1 适用范围和目的 Scope and object: IEC61000-4-3测试中的场地均匀性校准 The calibration of field in IEC61000-4-3 引用文件 Normative references IEC 61000-4-3：1998 电磁兼容 试验和测量技术射频电磁场辐射抗扰度试验 Testing and measurement techniques- Radiated, radio-frequency, electromagnetic field immunity test 校准使用的仪器设备： Test equipment: 3m法电波暗室 Anechoic chamber 射频信号发生器 RF signal generators: 宽频功放 power amplifier 发射天线 field generating antennas 场强探头 field strength monitoring antenna 场强仪 field strength monitor 功率仪 power meter  4 校准过程： 场强探头位置的确定 Locate the field strength probe position 确认IEC61000-4-3标准测试中所使用垂直均匀域平面，定出需要校准的16个点的位置； Locate the vertical uniform area and the 16 measuring point for calibration as following: 1312223242434441313334242321141111 13 12 22 32 42 43 44 41 31 33 34 24 23 21 14 11 11 Figure1 测试中，场强探头应放置在如图1所示的16个点上，其中场强探头的垂直投影应分别落在图2所示的地面上的1、2、3、4点上，如图2;场强探头的高度应在图3所示的1、2、3、4位置： During the test, the field strength probe should be put in the 16 poison as shown in figure1,the vertical projection of the probe should located on position 1 to 4 on the ground as shown in figure 2, and the height of the probe should be at position 1 to 4 in figure 3. 1243 1 2 4 3 Figure2 Figure 31234 Figure 3 1 2 3 4  吸波材料位置的确认 Locate the absorber position 在地面上铺设使用的吸波材料，记录吸波材料的配设位置, mark1至mark4分别为吸波材料铺设的4个角； Put additional absorber on the ground, and record the position of the 4 angle of the absorber as in figure 4: Mark4Mark 3M Mark4 Mark 3 Mark 1 Mark 2 Figure 4 将天线放置在距离垂直均匀域平面3m远的位置处 Put the antenna on the point 3m away from uniform field area and make sure the direction of the antenna perpendicular to the uniform field area as in figure 5: Figure