EMERSON艾默生 Instruction Sheet Mercmaster LED Low Profile Luminaires to Crouse-Hinds Champ Series Mounting Hoods Appleton说明书用户手册.pdf

650518-000 INSTRUCTION SHEET Installation Instructions for Mercmaster™ LED Low Profile Luminaires to Crouse-Hinds Champ Series Mounting Hoods FOR PROPER SAFE INSTALLATION OF THESE PRODUCTS, PLEASE READ THE FOLLOWING INSTRUCTIONS. Applications • Marine and wet locations. • Areas where flammable gases and vapors are present under conditions defined by the ratings below. • Areas of low clearance, low ceiling heights, or where luminaire weights must be minimized. • Non-hazardous locations where severe weather conditions, excessive moisture, dirt, dust, corrosive atmospheres and high ambient temperatures are encountered. Agency Ratings • Class I, Div. 2, Groups A, B, C and D • Class I, Zone 2, Group IIC • Class II, Div. 2, Groups F G • Class III • Type 3R, 4 and 4X • Wet Locations • Marine outside type (salt water) NOTE: For U.S. applications only. Product Safety Signal Words Defined DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury. WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury. CAUTION indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. NOTICE is used to address practices not related to physical injury. Safety Instructions WARNING: Do not open or remove the luminaire with the circuit energized. WARNING: Do not use this luminaire on ungrounded systems. Failure to ground the luminaire can result in an electric shock, which may be fatal. WARNING: Do not use on ungrounded 480 Volt circuits. CAUTION: Do not look directly at the LEDs when energized. NOTICE: Do not touch the LEDs; touching could leave oily deposits, causing hot spots and potential premature failure. NOTICE: When installing in a hazardous location, it is necessary that the globe and