TCP IP接口读写器配置与连接设置说明.pdfVIP

TCP/IP接口设置说明

打开RFIDDemo文件夹中的RFIDDemo.exe，

将的RJ45接口(水晶头或者网口)连接到电脑RJ45接口(水晶头或者网口)或者将读写

器的RJ45接口连接到电脑所在的局域网中。

上电，然后开始TCP/IP引擎的配置；

以下是以连接电脑为例，电脑IP地址和规划的IP地址要属于同一网段地址下，

可进行连接配置（192.168.0.xxx,Mask255.255.255.0）

运行NETConfig软件图解

1.打开RFIDDemo.exe：

TCP/IPinterfacereader/writersettinginstructions

OpenRFIDDemo.exeintheRFIDDemofolder,andconnecttheRJ45interface(crystalheadornetworkport)ofthe

reader/writertotheRJ45interface(crystalheadornetworkport)ofthecomputerorconnecttheRJ45interfaceoft

hereader/writertotheLANwherethecomputerislocated.Thereaderispoweredon,andthentheconfigurationof

thereadersTCP/IPengineisstarted;

Thefollowingisanexampleofareader-writerconnectedtoacomputer.ThecomputerIPaddressandthenned

reader-writerIPaddressmustbelongtothesamenetworksegmentaddress,andtheconnectioncanbeconfigured

(192.168.0.xxx,Mask255.255.255.0)

DiagramofrunningNETConfig

software

1.OpenRFIDDemo.exe:

2.选择”网络通讯(TCPIP/WIFI)”,点击界面上部”搜索联网设备”;

3.搜索的TCP/IP地址：

2.SelectNetworkCommunication(TCPIP/WIFI)andclickSearchforNetworkedDevices

atthetopoftheinterface;

3.SearchfortheTCP/IPaddressofther

eader:

4.获取的TCP/IP配置参数：

5.配置的TCP/IP配置参数：

将IP地址等信息设置到和你电脑IP网段;

4.GettheTCP/IPconfigurationparametersofthe

reader:

5.ConfiguretheTCP/IPconfigurationparametersofthe

reader:settheIPaddressandotherinformationtothe

sameIPnetwor