Gsm呼叫流程(课件).ppt

* * * * Three Location Updating tye : Normal Location updating : used to update the regeistration of the actual LA of a MS in the Network Periodic Location Updating : to notifiy periodically the availability of the mobile in the network. This procedure is controlled by a timer (T3212) in the MS. The timer is stopped and reset to 0 when : LU accept or Reject message is received, MS has respond to a paging, MS is deactivated. IMSI Attach : to activate a MS in the Network If T3210 expires, then T3211 starts. When T3211 reaches 0, the location update procedure is restarted. * * * * If Intracell Handover is disabled, cause 15 & 16 are switched to cause 2 & 4 If repetition of Intracell Alarm is disabled, cause 15 & 16 are switched to cause 2 & 4 * * * * C10 : incremented when a successfull SDCCH Handover is completed. C15 : incremented when a RTCH channel has been successfully selected for HO Purpose C17 : incremented on the target cell when a succesffull RTCH HO is completed. C39 incremented when an SDCCH subchannel of a TS is selected by the BSS. * * * * T3107 Expiry : indicates that the intra-cell HO failed. C07 : incremented on the serving cell when a MS fails to return to the old Channel after an unsuccessfull SDCCH Handover. C08 : incremented on the serving cell when a MS fails to acess the new channel during an SDCCH HO Procedure * * * * * * * * Authentifiaction procedure (MM Procedure): To check if the identity of the mobile is acceptable or not. Provide parameters enabling MS to calculate the new ciphering key. This procedure is used at each call setup, suplementary service, location updating. Identification procedure (MM Procedure) : Procedure used by the network to request a Mobile station to provide his IMSI Ciphering Mode setting procedure (RR Procedure) :Used to set the ciphering mode. Indicate wether ciphering shall be used or not and if yes which algortihm to use TMSI Realloc Proc (MM Procedure) : Provide identity confidentiality to the MS. Th