基于运算放大器的带通滤波器的设计与物理实现-毕业论文.doc

基于运算放大器的带通滤波器的设计与物理实现 院 系：机电与自动化学院 专 业 班：自动化 姓 名： 学 号： 指导教师： 2013年5月  基于运算放大器的带通滤波器的设计与物理实现 Design and Physical Implementation of Band-pass Filter Based on Operational Amplifier 摘 要 几乎在所有的工程技术领域中都会涉及到信号处理问题。滤波器作为信号处理的重要组成部分，已发展的相当成熟。有源带通滤波器以其良好的幅频特性，在信号的分析与测量中得到广泛应用。根据标准有源带通滤波器原理，采用频域分析法，可得出有源带通滤波器的特征频率计算公式。 关键词：有源窄带带通滤波 频域分析 幅频特性 高阶带通滤波器 Abstract Active band-pass filter with good frequency characteristics, widely used in signal analysis and measuring. According to the principle of active band-pass filter criteria, using frequency domain analysis, a formula to calculate characteristic frequencies of the active band-pass filter. This thesis based on the actual requirements, have designed a band-pass filter with center frequency of 500Hz, gain of 1, and pass band 20Hz.Here introduces Butterworth and Chebyshev response common response principle of operational amplifier and filter of low order and high order filter. And in the Filter Pro development environment using cascade design method is designed to meet the requirements of a high order active band-pass filter. Because of the requirements of filter pass band is narrow, and the steep cut-off frequency, this design uses the properties of the ideal uA741, in the Tina-Ti environment further tuning approach the actual simulation of the circuit parameters, and at the same time the analog input of the effective signal and interference signal, has been in line with the requirements of the output waveform. Finally, building and debugging of the actual circuit based on ideal digital amplitude characteristic simulation. Key words: active narrow-band band-pass filter frequency-domain analysis amplitude- frequency characteristics high order band-pass filter 目 录 摘要I Abstract………………………………………………………………………………II 绪论1 1 带通滤波器简介及设计方案………………………………………………………2 1.1 滤波器简介………………………………………………………………………2 1.2 有源带通滤波器的设计要求指标………………………………………………3 1.3 方案选择与讨论…………………………………………………………………3 2 低阶有源带通滤波器设计…………………………………………………